-
Step2: establishing a secure connection
Remember to turn off your car from where you have a 12v in both plug and open the door when about to charge. Now attach the red cable to positive (+) terminal of battery and black cable to negative (-).parseLong Double check all the wires connected properly again, make sure no wire touch other metal to prevent short-circuit!
Step 3: Select The Charging Mode in a Proper Way
Now you have to make the charger in charge mode according your battery specification. Follow instructions closely to ensure the charging process is congruent with your battery.
-
Activate the charging process
Once you are confident the charges were connected properly and did many if not all combinations changes else where in map, It will be time to plug your charging device perform finalizing by plugging it in then turn oncharging as well. Plug your Onewheel into the charger, relax and it should get the charge cycle started on its own. Charging Uptime(single): Will vary according to the charger efficiency & battery capacity. Then simply let your battery recharge but fully charge it at least one time per month.
-
Step 5: End the Charge Safely
When it is fully charged battery need to be stopped charging so now we are going to stop the process. First, turn the charger off and unplug it from power. Disconnecting the charger from battery must be done with very little risk, which means this should happen one step at a time after you have first removed the black cable and then turned your attention to removing red.
After following all these steps in detail, you will get perfect for charging the car battery with charger without to compromise your vehicle performance and remain at minimal mental stress. With what you have learned about charging, get out there and charge safely with some peace of mind. Happy charging!
